Nissan Pathfinder: Mirrors

Manual anti-glare rearview mirror

Use the night position 1 to reduce glare from the headlights of vehicles behind you at night.

Use the day position 2 when driving in daylight hours.

WARNING Use the night position only when necessary, because it reduces rear view clarity.

Automatic anti-glare rearview mirror

The inside mirror is designed so that it automatically dims during night time conditions and according to the intensity of the headlights of the vehicle following you. The automatic anti-glare feature is activated when the ignition switch is in the ON position.

NOTE: Do not hang any objects over the sensors 1 or apply glass cleaner to the sensors.

Doing so will reduce the sensitivity of the sensors, resulting in improper operation.

Outside mirrors

Basic Information

The outside mirror remote control will operate when the ignition switch is in the ACC or ON position or after the ignition switch is placed in the OFF position for 45 seconds or until a door is opened.

Push the switch 1 or 2 to select the left or right mirror. Adjust each mirror to the desired position using the large switch 3.

Push the switch 1 or 2 and make sure that the corresponding light is off, to prevent accidentally moving the mirror.

WARNING

• Objects viewed in the outside mirror on the passenger side are closer than they appear. Be careful when moving to the right. Using only this mirror could cause an accident. Use the inside mirror or glance over your shoulder to properly judge distances to other objects.
• Do not adjust the mirrors while driving.

  You could lose control of your vehicle and cause an accident.

Manual folding outside mirrors (if so equipped)

Pull the outside mirror toward the door to fold it.

Power folding outside mirrors (if so equipped)

CAUTION

• Do not touch the mirrors while they are moving. Your hand may be pinched, and the mirror may malfunction.
• Do not drive with the mirrors stored.

  You will be unable to see behind the vehicle.

Push the switch 1 to open the mirrors.

Push the switch again to close the mirrors.

If one of the mirrors are manually operated or bumped, the mirror body can become loose at the pivot point. To correct electronic mirror operation, cycle the mirrors by pushing the switch 1 until completely closed, then push the switch again until the mirrors are in the open position

Heated mirrors (if so equipped)

The electric control type outside mirrors can be heated to defrost, defog, or de-ice for improved visibility.

Reverse tilt-down feature (if so equipped)

The reverse tilt-down feature will turn both outside mirror surfaces downward to provide better rear visibility close to the vehicle.

The mirror control switch must be in either the L or R position.

The mirrors automatically return to their original position when you shift out of R (Reverse).

The outside mirror surfaces will return to their original position when one of the following conditions has occurred:

• The shift lever is moved to any position other than R (Reverse).
• The outside mirror control switch is set to the neutral or center position.
• The ignition switch is placed in the OFF position.

The reverse tilt position can be changed.

While in R (Reverse), adjust the glass position to the desired location. The next time the vehicle is shifted into R (Reverse), the glass position will go to the newly set position.

Additionally, the changed reverse tilt position can be saved to a memory seat position. After the reverse tilt glass position has been changed, vehicle is shifted back into park and glass has returned to the original position, push the Set switch and push the desired memory switch (1 or 2) to assign the new reverse tilt position memory.

NOTE: If the outside mirror control switch is in the center position, the mirror surface will NOT turn downward when the shift lever is moved to R (Reverse).